Metal bending?

[jeepchipjones]

Im looking for a place to bend some metal for me, so I can make some rocker guards. I might be getting my hands on some 1/4" diamond plate, but if that doesnt pan out, Ill probably just buy it from a metal shop and get them to put a 90 on it for me. Hey Jason, didnt you say you knew of a place in West Point? I dont know of any here in Starkville. I measured the other day and I need 2 sheets of 1' x 5', and Ill add tubing to it later Im sure. While on the subject, how much is tubing these days (1.75" x .125")? I need about 70' of it I believe for my next project(s). ;D

[JWP]

Ormans welding could bend plate for you. I used Longbranch. They are next to 4 county in West Point.

Most any Machine/Fabrication shops will have a press brake that can bend plate.

1.75 tubing runs around $2 per foot.

[jeepchipjones]

Thanks Jason, Ill look them up.