|
Post by rccolacc on Mar 14, 2011 9:28:48 GMT -5
Zach (Auburnaviator) has a 8.8 that he wants to put 5.38 gears and an ARB locker in. He's taking the axle apart and making setup bearings the next few days and wants to regear it Thursday. SO-- gear party on Thursday 3/17 at 6pm at my shop. The shop is located at 211 Collegeview St behind the Crossroads International Friendship house. Zach is providing pizza or something for the party. -RC
|
|
|
Post by auburnaviator on Mar 14, 2011 16:56:16 GMT -5
Everyone is more than welcome to come and help out, the more people the better. RC I'm going to try and get the bearings ground out for the set up bearings but might not have time between now and then b/c of work. I am off on Thursday a little after lunch so if the shop will be open I could bring my die grinder down and I could work on them then. If not no big deal and I can do it that night while someone is getting the housing ready for the ARB.
|
|
|
Post by rccolacc on Mar 16, 2011 10:05:41 GMT -5
The shop's not open, but I'll be home from work around 5 or so. Just come over whenever you want and we'll get it done. Is your die grinder air or electric? We may need to use a dremel or something to grind the bearing out. My compressor isn't that big and I think an air grinder will make it run too long. We can use a drill or a dremel or something though. No big deal. -RC
|
|
|
Post by auburnaviator on Mar 16, 2011 19:32:02 GMT -5
It's an air die grinder so unless I bring my compressor we'll have to use a dremel. Do you have a dremel? I'll try to be there around 5 or so.
|
|
|
Post by rccolacc on Mar 17, 2011 9:44:39 GMT -5
Your fine. Just bring the air grinder. We'll get it. -RC
|
|
|
Post by auburnaviator on Mar 17, 2011 16:46:19 GMT -5
Going to be more like 6, didn't get out of work in time..... I hate 12+ hour days!
|
|
|
Post by rccolacc on Mar 22, 2011 15:31:06 GMT -5
|
|
|
Post by rccolacc on Mar 22, 2011 15:38:34 GMT -5
|
|